Tumble dryer displays error message E80

Issue

Tumble dryer displays error message E80. It indicates a problem with the cycle selector or the software

Applies to

Condenser dryer
Heat pump dryer

Resolution

1. Make sure the cycle selector is not set between two programme options.

2. Reset the appliance.

Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
After plugging in the appliance, switch it on and select a program.

3. Contact an Authorized Service Center.

If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.

Was this article helpful?

Spare parts & Accessories

Find original spare parts for your appliance in our webshop and have them delivered directly to your door.

To the webshop

Book a repair

Need to arrange a repair technician visit? Repairs in warranty are free of charge and we are here to support you after your warranty has expired. Authorised Technicians and genuine parts for complete peace of mind.