Tumble dryer displays error code E9E
Issue
- Tumble dryer displays error code E9E
Applies to
- Tumble dryers
Resolution
- Check main power supply, switch off other running appliances if necessary
- The appliance is probably placed in a small closed storage room and is overheating or the air is heavy with moisture due to the lack of ventilation. Make sure that the appliance is installed in an environment with sufficient air exchange
- Clean the fluff filter and the heat exchanger area. Clean the filter after each drying cycle. Refer to the article:
Cause
- Electrical noise
- Humidity/water on UI board
Was this article helpful?
Related Articles
- Tumble dryer displays error code E54
- Tumble dryer emits unusual noises
- Tumble dryer’s water tank is empty
- Tumble dryer ends the programme immediately after the start
- Tumble dryer displays error message EHO, EH0
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message "Err"
- Water leakage from under the dryer
- Heat pump dryer's drying cycle is too long
- Tumble dryer displays error message E50