Electrolux Washing Machine Making Unusual Noises During Draining or Spinning – Causes and Solutions

Issue

If your Electrolux washing machine is making unusual noises during the draining or spinning phase, the cause is often related to the position or installation of the drain hose or inlet hose.

In many cases, these sounds are normal installation-related noises rather than a fault with the appliance. Incorrect hose positioning can affect water flow, airflow, or create vibrations against the appliance cabinet.

You may experience:

Typical signs

• Gurgling or bubbling sounds during draining
• Suction-like noises from the drain hose connection
• Louder humming sounds while water is being pumped out
• Vibrations or knocking noises during draining or spinning
• Noise that occurs only during specific parts of the programme
• Hoses touching the appliance cabinet or surrounding surfaces

Applies to

• Electrolux washing machines
• Electrolux washer dryers

Resolution

Start by checking the most common installation-related causes. In many cases, the noise can be reduced or eliminated without service.

1. Check how the drain hose is installed

Make sure the drain hose has not been inserted too far into the standpipe or household drain.

If the hose is pushed in too deeply, airflow can be restricted and this may cause:

• Gurgling sounds
• Bubbling noises
• Suction-like sounds during draining

Adjust the hose according to the instructions in your user manual.

2. Inspect the drain hose for bends or kinks

Check the full length of the drain hose.

Make sure it is not:

• Bent sharply
• Kinked
• Twisted
• Crushed behind the appliance

Restrictions can make the drain pump work harder and may increase operating noise.

3. Check the inlet hose position

Ensure the inlet hose is routed correctly and is not touching the appliance cabinet.

A hose that vibrates against the cabinet can create additional noise, especially during spinning.

4. Keep hoses away from the cabinet

Check that both the drain hose and inlet hose have enough clearance.

If a hose is touching:

• Side panels
• The rear panel
• Nearby furniture or pipes

it can transmit vibration and create rattling or knocking sounds.

5. Verify the installation follows the user manual

Correct installation helps ensure proper water flow and reduces unnecessary noise.

Check that:

• The drain hose is installed at the recommended height
• Hoses are properly supported
• Water can flow freely through the drain system
• Installation follows the instructions for your specific model

Refer to your appliance user manual for detailed guidance.

Important

Some sounds are a normal part of washing machine operation and do not indicate a fault.

The noise level may vary depending on:

• Appliance installation
• Floor type
• Drainage system design
• Selected spin speed
• Laundry load size and distribution

Modern washing machines may also sound different from older models due to changes in pump and motor design.

When Is It Not a Fault?

The following sounds are typically normal:

• Humming or buzzing while the drain pump is operating
• Clicking sounds when the appliance changes cycle stages
• Water moving inside the drum during washing
• Brief thumping as the machine balances the load before spinning
• High-speed spinning noise during spin cycles
• Water filling sounds
• Door locking and unlocking clicks
• Light rattling from zips, buttons, or other clothing accessories

If the appliance drains and spins correctly and no error message is displayed, these sounds are usually part of normal operation.

Still need help? Get expert support

If the issue continues, a professional technician can help diagnose and fix the problem.

No matter if your appliance is in warranty, out of warranty, or covered by an appliance protection plan - we’ll guide you to the right service.

Book a repair online

Cause

The issue is often caused by hose installation or positioning rather than a fault with the appliance.

Common causes include:

• Drain hose inserted too far into the standpipe
• Bent, kinked, or twisted drain hose
• Drain or inlet hoses touching the appliance cabinet
• Hoses routed incorrectly behind the appliance
• Airflow and water-flow characteristics within the household drain system

Less commonly, unusual noises may be caused by a blocked drain system, a foreign object, or a component fault.

FAQ

Why does my Electrolux washing machine make a gurgling sound when draining?

This is often caused by airflow in the drain system or the drain hose being inserted too deeply into the standpipe.

Is a humming noise during draining normal?

Yes. The drain pump typically produces a humming sound while removing water from the appliance.

Why do I hear a suction-like noise?

This can occur when airflow around the drain hose is restricted during draining.

Can hose positioning cause vibration?

Yes. Hoses that touch the cabinet or nearby surfaces can transfer vibration and create additional noise.

Should I straighten a bent drain hose?

Yes. Removing bends, twists, and kinks can improve water flow and reduce noise.

When should I contact service?

If the appliance does not drain properly, displays an error code, leaks water, or continues to make excessive mechanical noises after the installation checks, further inspection may be required.