Tumble dryer - How to replace drive belt (4)
Applies to
- Tumble Dryers
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety glovesif you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Always empty the appliance of all the water, e.g. tumble dryer water container. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
1. Remove the screws which secure the top to the rear edge of the appliance and remove it pushing it towards the rear side
2. Remove the screws which secure the side panel to the rear panel, lift and remove.
3. Remove the belt tensioner spring (4):
4. Cut the damaged belt (1)
5. Remove the rear panel: Remove the screws (1) which secure the plastic rear panel cover (in the centre of the panel) and release the anchor tabs (2) from around the external perimeter using a screwdriver.
Remount the new belt paying attention to remount it centrally considering the motor shaft (see chapter).