Tumble dryer does not switch on after a drying cycle
Resolution
Issue:
- Tumble dryer does not switch on after a drying cycle. It indicates a technical problem with the appliance.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Contact an Authorized Service Center.
We recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Tumble dryer is leaking
- Tumble dryer emits unpleasant smells
- Tumble dryer not drying, not drying properly, too long drying
- How to change the dryer door opening directions?
- Tumble Dryer displays error code E50 - Causes and Solutions
- Tumble dryer's drying results are poor and laundry is damp after drying
- Cleaning tumble dryer filters and condenser
- What can water from a tumble dryer be used for?
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- Tumble dryer displays a padlock
Related Articles
- Tumble dryer is leaking
- Tumble dryer emits unpleasant smells
- Tumble dryer not drying, not drying properly, too long drying
- How to change the dryer door opening directions?
- Tumble Dryer displays error code E50 - Causes and Solutions
- Tumble dryer's drying results are poor and laundry is damp after drying
- Cleaning tumble dryer filters and condenser
- What can water from a tumble dryer be used for?
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- Tumble dryer displays a padlock