Tumble dryer displays error code E9E
Issue
- Tumble dryer displays error code E9E
Applies to
- Tumble dryers
Resolution
- Check main power supply, switch off other running appliances if necessary
- The appliance is probably placed in a small closed storage room and is overheating or the air is heavy with moisture due to the lack of ventilation. Make sure that the appliance is installed in an environment with sufficient air exchange
- Clean the fluff filter and the heat exchanger area. Clean the filter after each drying cycle. Refer to the article: Cleaning tumble dryer filters and condenser
Cause
- Electrical noise
- Humidity/water on UI board
Was this article helpful?
Related Articles
- Tumble dryer displays a padlock
- How to reset WiFi network settings on my Electrolux dryer
- Clothes are still wet at the end of the drying cycle
- Tumble dryer does not start / does not work
- Tumble Dryer Has No Power or Does Not Start
- Cleaning tumble dryer filters and condenser
- What can water from a tumble dryer be used for?
- Tumble dryer displays error code EBD
- Heat pump dryer's drying cycle is too long
- How to change the dryer door opening directions?
Spare parts & Accessories
Find original spare parts for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- Tumble dryer displays a padlock
- How to reset WiFi network settings on my Electrolux dryer
- Clothes are still wet at the end of the drying cycle
- Tumble dryer does not start / does not work
- Tumble Dryer Has No Power or Does Not Start
- Cleaning tumble dryer filters and condenser
- What can water from a tumble dryer be used for?
- Tumble dryer displays error code EBD
- Heat pump dryer's drying cycle is too long
- How to change the dryer door opening directions?