Tumble dryer displays error code E70
Issue
- Dryer shows error message E70 on the display
- E70 code on tumble dryer
Applies to
- Dryers
Resolution
1. Reset the appliance's control electronics by unplugging the appliance for 2 hours and then plugging it back in.
2. If this does not solve the problem and the error persists, contact our Consumer Care Centre
A service visit by one of our approved service providers is recommended.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Cause
- Error code E70 indicates a problem with the temperature sensor
Was this article helpful?
Related Articles
- How to clean and maintain your Electrolux tumble dryer to prolong its life
- Heat pump dryer's drying cycle is too long
- Tumble dryer has no power
- Tumble dryer does not start / does not work
- Before using your Electrolux tumble dryer for the first time
- When I open my Electrolux tumble dryer, there is a large amount of lint / fluff
- Tumble dryer is leaking
- The time displayed on the tumble dryer display does not match the time indicated on the energy label
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Tumble dryer emits unpleasant smells