Dishwasher displays error code iC0 / iCo
Issue
- Dishwasher displays error message iC0, iCo, iC1, iC2 or iC3
- My dishwasher is not working
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
Reset your appliance:
- Remove the plug for the dishwasher
- Check your dishwasher filter and sump (see below) for signs of foam/suds & debris
- Make sure you clean all the filters
- Clean any foam/suds from the sump
- Plug it back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
If the above steps don't resolve the issue then a service visit by one of our approved service providers is recommended.
Cause
- iC0 code family indicates a technical malfunction of the appliance
Was this article helpful?
Related Articles
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher door will not close properly or is crooked
- Dishwasher shows d: on in display / DEMO mode deactivation
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwashers has poor washing results
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
- Water is being filled into the dishwasher even when it is turned off
- Where and how do I change the basic settings on my AEG dishwasher
- Dishwasher displays error code i30
- Symbols and programmes on your Electrolux dishwasher