Clothes are too creased after drying in tumble dryer
Issue
- Clothes are too creased after drying in tumble dryer
- Tumble dryer heats up too much
Applies to
- Condenser dryer
- Heat pump dryer
Resolution
1. Choose a suitable drying program.
Use a time program, do not dry too long.
Check your user manual for information about the drying time required for different types of laundry.
Download user manual
2. Remove the laundry immediately after the end of the programme.
If necessary extend the crease protection phase or use the start time delay (if available).
Note: Wool and duvet programmes have no anti-crease protection.
3. Do not exceed the maximum load stated in programmes chapter or shown on the display.
Was this article helpful?
Related Articles
- Cleaning tumble dryer filters and condenser
- Tumble dryer displays error message E20, C2 or emits 2 beeps / 2 flashes
- Tumble dryer blows fuses / trips RCD circuit breaker
- Tumble dryer’s water tank is empty
- Water leakage from under the dryer
- Tumble dryer not drying, not drying properly, too long drying
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- Warning light(s) of tumble dryer cannot be switched off
- Condenser Dryer Drain Kit
- How to change the dryer door opening directions?
Related Articles
- Cleaning tumble dryer filters and condenser
- Tumble dryer displays error message E20, C2 or emits 2 beeps / 2 flashes
- Tumble dryer blows fuses / trips RCD circuit breaker
- Tumble dryer’s water tank is empty
- Water leakage from under the dryer
- Tumble dryer not drying, not drying properly, too long drying
- Tumble Dryer generates scraping/rubbing noise while drum rotating
- Warning light(s) of tumble dryer cannot be switched off
- Condenser Dryer Drain Kit
- How to change the dryer door opening directions?