Clothes are too creased after drying in tumble dryer
Issue
- Clothes are too creased after drying in tumble dryer
- Tumble dryer heats up too much
Applies to
- Condenser dryer
- Heat pump dryer
Resolution
1. Choose a suitable drying program.
Use a time program, do not dry too long.
Check your user manual for information about the drying time required for different types of laundry.
Download user manual
2. Remove the laundry immediately after the end of the programme.
If necessary extend the crease protection phase or use the start time delay (if available).
Note: Wool and duvet programmes have no anti-crease protection.
3. Do not exceed the maximum load stated in programmes chapter or shown on the display.
Was this article helpful?
Related Articles
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Cleaning tumble dryer filters and condenser
- Start - Pause LED flashes on tumble dryer
- Tumble dryer’s water tank is empty
- Warning light(s) of tumble dryer cannot be switched off
- Tumble dryer's Condenser LED is on
- Condenser Dryer Drain Kit
- Clothes are still wet at the end of the drying cycle
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble Dryer Has No Power or Does Not Start
Related Articles
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Cleaning tumble dryer filters and condenser
- Start - Pause LED flashes on tumble dryer
- Tumble dryer’s water tank is empty
- Warning light(s) of tumble dryer cannot be switched off
- Tumble dryer's Condenser LED is on
- Condenser Dryer Drain Kit
- Clothes are still wet at the end of the drying cycle
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble Dryer Has No Power or Does Not Start