Water is flowing back into the dishwasher
Issue
- Water is flowing back into the dishwasher. The problem is caused by the drain hose.
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
1. Ensure that the drain hose has been installed correctly.
Make sure that:
- The length of the drain hose does not exceed 400 cm.
- The drain inlet point must be between 40 and 85 cm.
- The drain hose is not damaged, kinked or twisted.
2. Contact an Authorized Service Center.
If the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Note: The multi-tablet function must be enabled after you select a cycle and will not be saved in the memory.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- Symbols and programmes on your Electrolux dishwasher
- How to clean and maintain your Electrolux dishwasher
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error code i30
- Dishwasher displays error code i50
- Dishwasher door will not stay open
- Dishwasher does not / will not start but the power is on
- Dishwasher shows d: on in display / DEMO mode deactivation
- Dishwasher does not switch on, no light on the control panel
- Water is being filled into the dishwasher even when it is turned off