Tumble dryer displays error message E50
Resolution
Issue:
- Tumble dryer displays error message E50. It indicates a motor or software problem.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
2. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Tumble dryer does not start / does not work
- Tumble dryer’s water tank is empty
- Cleaning tumble dryer filters and condenser
- Tumble dryer emits unusual noises
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer's drying cycle does not end / Does not sense when clothes are dry
- Condenser Dryer Drain Kit
- Tumble dryer's drying results are poor and laundry is damp after drying
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle