PF error code is displayed on the dishwasher's display
Issue
- Dishwasher shows error code PF on the panel
Applies to
- Freestanding dishwasher
- Built-in dishwasher
Resolution
- PF (Power Failure) code indicates low operating voltage
- The electrical supply voltage is out of range and might indicate a fault in your electrical installation. The washing program is temporarily stopped. As the electrical voltage improves, the machine continues to operate automatically.
- To avoid damage to the machine, we recommend leaving the dishwasher switched off until the voltage is OK, and not using the appliance.
- Book a repair
If the above did not solve the problem, we recommend booking a repair.
Was this article helpful?
Related Articles
- Rust spots on cutlery after washing in the dishwasher
- Symbols and programmes on your Electrolux dishwasher
- Dishwasher displays error code i30
- Dishwasher door does not close
- Dishwasher displays error code iC0 - Causes and Fixes
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Dishwasher does not beep at the end of the cycle
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error code iF0, iFo or iF1
- How to change the drain filter in my Electrolux dishwasher? (video)
Related Articles
- Rust spots on cutlery after washing in the dishwasher
- Symbols and programmes on your Electrolux dishwasher
- Dishwasher displays error code i30
- Dishwasher door does not close
- Dishwasher displays error code iC0 - Causes and Fixes
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Dishwasher does not beep at the end of the cycle
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error code iF0, iFo or iF1
- How to change the drain filter in my Electrolux dishwasher? (video)