Opening washing machine's door at the beginning of wash cycle
Issue
- Opening washing machine's door at the beginning of wash cycle
- Can I add clothes to the washing machine after the cycle has started?
Applies to
- Washing machines
- Washer dryers
Resolution
Please note: If your machine is quite far into a cycle, you will need to cancel the cycle and drain the machine as will not unlock while it is hot and full of water or if the drum still rotates. To cancel a cycle, press the on/off button and turn the dial to rinse/spin and begin this cycle to drain your machine. This can also be done via the app if you have a connected appliance.
If you have forgotten garments that need to be added to the wash, the cycle can be paused, and the door can be opened in the first 20 minutes on a full cycle. This window of time will decrease based on the cycle you are using. You can open the door anytime during the delayed start.
- Press the Start/Pause button
- Wait until the lock icon on your display switches off/you hear the door unlock. If this does not happen within 1 minute, you are too far into the cycle to open the door.
- You may open the door and add or remove your garments
- Close the door and press the Start/Pause button again to resume the cycle.
- The cycle or delayed start will continue
Warning: If the door can be opened during a wash or spin cycle, when the washing machine is filled up with water, switch off the power supply to the appliance immediately.
Do not use the washing machine until the problem is solved. Contact an Authorised Service Center to arrange a repair.
Was this article helpful?
Related Articles
- Washing machine does not work / does not react
- The door of the washing machine cannot be opened
- How to reset WiFi network settings on my Electrolux washing machine?
- Fabric conditioner runs directly down into the washing machine's drum
- Washing machine blows fuses / trips RCD circuit breaker
- Can the washing machine's door be reversed?
- Fabric conditioner does not dissolve in my washing machine
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- After cleaning the pump filter, the washing machine hums and does not start washing
- How to drain a washing machine/washer dryer