Dishwasher door shifts up during a wash cycle
Resolution
Issue:
- Dishwasher door shifts up during a wash cycle
Applies to:
- Integrated dishwasher
- Freestanding dishwasher
Resolution:
1. Contact the installer.
If your integrated dishwasher has been installed recently, the door panel may be too heavy, or the appliance may not have been installed correctly.
2. Check and, if necessary, wash out the spray arms, and clean the filters at the bottom of the unit in accordance with the user manual before using the appliance again.
If the appliance has been installed correctly, the problem may be blocked or clogged spray arms.
3. Contact an Authorized Service Center.
If your dishwasher is not integrated or recently installed, the dishwasher must be inspected and repaired by an engineer.
Was this article helpful?
Related Articles
- Dishwasher installation (Sliding door)
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Symbols and programmes on your Electrolux dishwasher
- Dishwasher does not / will not start but the power is on
- Dishwasher emits clicking/ticking noise during cycle
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Compact dishwasher displays error message E1, does not fill with water
- Dishwasher displays error code I20, C2, F2 or AL6, or beeps twice, not draining
- Dishwasher not cleaning properly
- Compact dishwasher displays error message E3