Washing Machine - How to replace the rubber bellow fixing spring

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety gloves if you perform maintenance or repair work involving belts.

WARNING! NOT INTENDED FOR CHILDREN

Keep all small parts and packaging out of reach of children under 3 years due to choking hazard. Installation and use should be performed by adults only.

-

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

How to replace the rubber bellow fixing spring

1. Unscrew the six PH2 screws on the lid and then slide back whilst lifting from the back to release.

2. Remove the detergent drawer by pressing down the tab at the back and sliding the drawer forward. Unscrew the two PH2 screws from the drawer housing.

3. Unscrew the five 8mm screws and the two Torx 20 screws securing the front panel and control panel.

4. Use a flat blade screwdriver to push in the securing tabs on the side of the detergent dispenser and also the tab that secures the control panel to the front panel.

5. Lift up the control panel and pull towards you to release (note: this may need to be done in conjunction with step four as the clips will likely click back into place).

6. Loosen the securing tab for the door seal and then unhook the door seal from the front cabinet.

7. Unscrew the two Torx 20 screws and push the door lock to the left to release.

8. Unscrew the three Torx 20 screws under the front panel of the washing machine and then unscrew the two PH2 screws on either side of the front panel to release the front panel from the body of the appliance.

9. Unscrew the two Torx 20 screws and push the door lock to the left to release.

10. Unscrew the three Torx 20 screws under the front panel of the washing machine and then unscrew the two PH2 screws on either side of the front panel to release the front panel from the body of the appliance.

11. Pull the front panel towards you to remove.

12. Unclip the retaining spring for the dryer condenser hose.

13. Slide the rubber door seal away from the dryer duct and use a flat blade screwdriver to unhook the fixing spring off the door seal.

14. When assembling repeat steps in reverse order. Note: When reinstalling ensure that the fixing spring is properly installed all the way round the door seal and drum.