Tumble dryer displays error code E70
Issue
- Dryer shows error message E70 on the display
- E70 code on tumble dryer
Applies to
- Dryers
Resolution
1. Reset the appliance's control electronics by unplugging the appliance for 2 hours and then plugging it back in.
2. If this does not solve the problem and the error persists, contact our Consumer Care Centre
A service visit by one of our approved service providers is recommended.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Cause
- Error code E70 indicates a problem with the temperature sensor
Was this article helpful?
Related Articles
- Tumble dryer emits unusual noises
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer does not start / does not work
- Tumble dryer's drying cycle does not end / Does not sense when clothes are dry
- Condenser Dryer Drain Kit
- Tumble dryer's drying results are poor and laundry is damp after drying
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle
- Tumble dryer displays error message "Err"
- Tumble dryer emits a louder noise during wool cycle