Electrolux fridge and freezer care guide: Do's and Don'ts

Resolution

Regular cleaning and maintenance help prevent unpleasant odours, maintain energy efficiency, and keep your Electrolux fridge and freezer in great condition. Follow these simple do’s and don’ts to help your appliances perform at their best.

Fridge cleaning and care

The do’s

• Do let shelves reach room temperature before cleaning. Remove them from the fridge and place them on a worktop before washing with warm water and mild washing-up liquid.

• Do clean the fridge interior regularly. Use a soft cloth with warm water, mild washing-up liquid or a specialist fridge cleaner.

• Do check and clean the door seals regularly. Wipe them with a soft, damp cloth to remove dirt and food residue.

The don’ts

• Don’t wash glass shelves or accessories in the dishwasher. Clean them by hand with warm water and mild washing-up liquid.

• Don’t use harsh chemicals or abrasive cleaners. Avoid scouring powders, chlorine-based products and oil-based cleaners that could damage the surfaces.

• Don’t place food directly against the rear interior wall. Food may freeze to the surface or block the drainage channel, preventing water from draining properly.

Freezer defrosting and care

The do’s

• Do prepare your freezer before defrosting. Lower the temperature to below −18°C approximately 12 hours beforehand to help keep frozen food cold for longer.

• Do turn off and unplug the freezer before defrosting. Move frozen food to a suitable cool place, leave the door open and place towels or a tray underneath to catch melting water.

• Do use warm water to help melt the ice. Place a pot of warm water inside the freezer and gently remove loosened ice with the supplied plastic scraper.

The don’ts

• Don’t use sharp tools to remove ice. Knives and metal scrapers can damage the freezer's interior surfaces.

• Don’t use hairdryers or other heating devices to speed up defrosting. These can damage the appliance and create a safety risk.

• Don’t put food back immediately after defrosting. Dry the interior thoroughly, then switch on the freezer at its coldest setting and let it run empty for at least 3 hours before putting the food back.

Filters and general maintenance

The do’s

• Do replace the CleanAir+ carbon filter every 6 months. Regular replacement helps maintain effective odour control and keep your fridge smelling fresh.

• Do dry all surfaces and components thoroughly after cleaning. Rinse away any cleaning product residue and make sure everything is completely dry before turning the appliance back on.

The don’ts

• Don’t block the air vents or temperature sensors. Keep food clear of these areas to allow proper air circulation and accurate temperature control.

A little regular maintenance goes a long way. Keep your fridge and freezer clean and in great condition with the right care products.

Explore our fridge and freezer care products.