Dishwasher - How to replace the foot adjusting screw

Applies to

  • Dishwashers

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety glovesif you perform maintenance or repair work involving belts.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE FOOT ADJUSTING SCREW
1. Remove the filter and it’s housing the use a small syringe and some old towels to drain the water in the sump.


2. Unscrew the four PH2 screws holding the bottom cover of the dishwasher and then pull the cover towards you to remove.



3. Carefully lift the dishwasher onto its left side. NOTE: Ensure you have full and correct floor protection against any damage or any residual water leaking.


4. Lift the foot adjusting screw out of the retaining clips on the base panel. (NOTE: During reinstallation check that the screw is operating correctly before lifting the dishwasher back up right).

5. Pull the foot adjusting screw out of the retaining slot in the basement and away from the cog for the back foot.


6. When assembling, repeat steps in reverse order.

Was this article helpful?

Spare parts & Accessories

Find original spare parts for your appliance in our webshop and have them delivered directly to your door.

To the webshop

Find your User Manual

Solve problems and find instructions and other documentation for your product.

Find manual

Book a repair

Need to arrange a repair technician visit? Repairs under warranty are free of charge and we are here to support you after your warranty has expired. Authorised Technicians and genuine parts for complete peace of mind.

Book a service