Dishwasher - How to replace the drain pump

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before any repair or maintenance operation, turn off water supply to the appliance.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE DRAIN PUMP

1. Remove the filter and it’s housing the use a small syringe and some old towels to drain the water in the sump.

2. Unscrew the four PH2 screws holding the bottom cover of the dishwasher and then pull the cover towards you to remove

3. Carefully pull the drain pump cover towards you to release from the drain pump

4. Carefully disconnect wiring connectors from the drain pump spade. (Note: Take a photo of the wiring positioning/location before disconnecting) Be careful not to damage the connectors.

5. Grab the body of the drain pump and twist anticlockwise to release the drain pump.

6. Pull to the right to release the seal on the drain pump.

7. When assembling, repeat steps in reverse order. Note: Ensure when re-screwing the pump back onto the housing ensure that all 3 clips are securely on the pump housing.