Dishwasher displays error code i70
Issue
- My dishwasher doesn't heat or displays error code i70
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
Reset your appliance.
- Remove the plug for the dishwasher
- Check your dishwasher filter and sump ( See below ) for signs of foam/suds & debris
- Making sure you clean all the filters
- Clearing any foam/suds from the sump. Plug it back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
If the above steps don't resolve the issue then a service visit by one of our approved service providers is recommended.
Cause
- Error code i70 - Temperature sensor in the sump is detecting a defect
Was this article helpful?
Related Articles
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Integrated built-in dishwasher door stuck closed
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Symbols and programmes on your Electrolux dishwasher
- How to disable the AirDry function in a dishwasher with a QuickSelect panel (level 1)
- Dishwasher salt consumption is too high
- Dishwasher displays error code I20, C2, F2 or AL6, or beeps twice, not draining
- How to add salt to your Electrolux dishwasher
- Before using your Electrolux dishwasher for the first time
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme